12Vdc的熒光燈驅動電路-12VDC Fluorescen
12Vdc的熒光燈驅動電路-12VDC Fluorescent Lamp Driver
A number of people have been unable to find the transformer needed for the Black Light project, so I looked around to see if I could find a fluorescent lamp driver that does not require any special components. I finally found one in Electronics Now. Here it is. It uses a normal 120 to 6V stepdown transformer in reverse to step 12V to about 350V to drive a lamp without the need to warm the filaments.
Schematic
Parts:
Part
Total Qty.
Description
Substitutions
C1
1
100uf 25V Electrolytic Capacitor
C2,C3
2
0.01uf 25V Ceramic Disc Capacitor
C4
1
0.01uf 1KV Ceramic Disc Capacitor
R1
1
1K 1/4W Resistor
R2
1
2.7K 1/4W Resistor
Q1
1
IRF510 MOSFET
U1
1
TLC555 Timer IC
T1
1
6V 300mA Transformer
LAMP
1
4W Fluorescent Lamp
MISC
1
Board, Wire, Heatsink For Q1
Notes:
1. Q1 must be installed on a heat sink.
2. A 240V to 10V transformer will work better then the one in the parts list. The problem is that they are hard to find.
3. This circuit can give a nasty (but not too dangerous) shock. Be careful around the output leads.
-
熒光燈
+關注
關注
1文章
152瀏覽量
29495
發布評論請先 登錄
相關推薦
請問ADN8831可以用于控制12VDC驅動的TEC嗎？
48VDC轉12VDC電路圖
50-250VDC轉12VDC
CR6850 12VDC開關電源電路（ALLEGRO源文件+PDF）
請問ADN8831能用于控制12VDC驅動的TEC嗎？
請問將兩節鋰電池輸出的8.4VDC轉換成12VDC用哪款芯片和電路？
求12VDC或5VDC隔離轉成12VDC隔離電源芯片推薦！
5VDC單極性至12VDC雙極性轉換器的電路圖
一個12VDC到9VDC的轉換器電路
12VDC移動電池充電器電路圖
工商網監
評論