電子發燒友App
Amplifier parts:
P1 = 22K Log.Potentiometer (Dual-gang for stereo)
R1 = 1K 1/4W Resistor
R2 = 4K7 1/4W Resistor
R3 = 100R 1/4W Resistor
R4 = 4K7 1/4W Resistor
R5 = 82K 1/4W Resistor
R6 = 10R 1/2W Resistor
R7 = R22 4W Resistor (wirewound)
R8 = 1K 1/2W Trimmer Cermet (optional)
???
C1 = 470nF 63V Polyester Capacitor
C2,C5 = 100?F 3V Tantalum bead Capacitors
C3,C4 = 470?F 25V Electrolytic Capacitors
C6 = 100nF 63V Polyester Capacitor
???
D1 = 1N4148 75V 150mA Diode
???
IC1 = TLE2141C Low noise,high voltage,high slew-rate Op-amp
???
Q1 = BC182 50V 100mA NPN Transistor
Q2 = BC212 50V 100mA PNP Transistor
Q3 = TIP42A 60V 6A??? PNP Transistor
Q4 = TIP41A 60V 6A??? NPN Transistor
???
J1 RCA? audio input socket
Power supply parts:
R9 = 2K2 1/4W Resistor
???
C7,C8 = 4700?F 25V Electrolytic Capacitors
???
D2 100V 4A Diode bridge
D3 5mm. Red LED
???
T1 220V Primary, 15 + 15V Secondary 50VA Mains transformer
???
PL1 Male Mains plug
???
SW1 SPST Mains switch?
?
Notes:
Can be directly connected to CD players, tuners and tape recorders.
Don't exceed 23 + 23V supply.
Q3 and Q4 must be mounted on heatsink.
D1 must be in thermal contact with Q1.
Quiescent current (best measured with an Avo-meter in series with Q3 Emitter) is not critical.
Adjust R3 to read a current between 20 to 30 mA with no input signal.
To facilitate current setting add R8 (optional).
A correct grounding is very important to eliminate hum and ground loops. Connect in the same point the ground sides of J1, P1, C2, C3 &C4. Connect C6 at the output ground.
Then connect separately the input and output grounds at the power supply ground.
Technical data:
Output power: 18 Watt RMS @ 8 Ohm (1KHz sinewave)
Sensitivity: 150mV input for 18W output
Frequency response: 30Hz to 20KHz -1dB
Total harmonic distortion @ 1KHz:? 0.1W 0.02%??? 1W 0.01%??? 5W 0.01%?? 10W 0.03%
Total harmonic distortion @10KHz: 0.1W 0.04%??? 1W 0.05%??? 5W 0.06%?? 10W 0.15%
Unconditionally stable on capacitive loads
工商網監
評論